Service Manual

determines how the system reacts to a modem signal
On LAN Power On If Advanced Power Management is enabled, this option
determines how the system reacts to a LAN wake up event
On PME Stay Off If Advanced Power Management is enabled, this option
determines how the system reacts to a PCI Power Management
enabled wake up event
Floppy check Disabled If set to Enabled, the system always verifies the diskette drive
type during boot. Selecting Disabled results in a faster boot.
IDE drive configuration Primary
Master IDE
Determines the boot search order for IDE devices connected to
the system
1st to 8th boot devices ATAPI CD-
ROM
Determines the boot search order for the types of boot devices
System Management Menu
Table 12. System Management Menu Categories
Feature Default
Value
Description
Serial console
redirection
Disabled Enables or disables serial port console redirection
Baud rate 19.2K Sets the transfer rate for console redirection
Flow control CTS/RTS Specifies the type of flow control used
Exit Menu
Table 13. Exit Menu Categories
Feature Description
Exit Saving Changes Select this option to exit the System Setup program and save changes.
Exit Discarding
Changes
Select this option to exit the System Setup program without saving changes.
Load Setup Defaults Select this option to reset all System Setup fields to their default values.
Load Custom
Defaults
This field saves all current System Setup field values as custom defaults. If the
system CMOS fails, the BIOS restores all System Setup values to these custom
values, if available. If not, the BIOS uses the factory default values.
Save Custom
Defaults
Saves your system's custom settings. This option has no user-configurable
settings.
Discard Changes Select this option to restore all System Setup fields to their previous values.