Service Manual

3-4 Dell PowerEdge 6300 Systems Service Manual
4-3-1 Faulty or improperly
seated DIMM,
DIMMs not installed
in sets of four, or a
faulty or improperly
seated memory
module
Be sure that the DIMMs are
installed in sets of four and in the
proper sockets for each memory
bank in use. If this does not
resolve the problem, remove and
reseat the DIMMs or the memory
module. If the problem persists,
replace the DIMMs or the memory
module.
4-3-3 Defective system
board
Replace the system board.
4-3-4 Time-of-day clock
stopped
Replace the battery. If the problem
persists, replace the system board.
4-4-1 Faulty I/O chip
Super I/O controller
failure
Replace the system board.
4-4-2 Parallel-port test fail-
ure (defective sys-
tem board)
Replace the system board.
4-4-3 Math coprocessor
failure (defective
microprocessor)
Replace the microprocessor.
4-4-4 Cache test failure
(defective
microprocessor)
Replace the microprocessor.
Table 3-1. System Beep Codes (continued)
Code Cause Corrective Action