Manualshelf

Service Manual

ManualsBrandsDell ManualsFax MachinePOWEREDGE 6300
51525354555657585960
Removing and Replacing Parts 4-5
Control Panel Assembly
Figure 4-3. Control-Panel Assembly Removal
To remove the control panel assembly, follow these steps:
1. Disconnect the ribbon cable from its connector on the left side of
the control panel assembly (see Figure 4-3).
2. Loosen the thumbscrew securing the control panel assembly to
the front of the chassis.
3. Slide the control panel assembly to the right (or up if system is in
rack-mount position) to disengage the card from the chassis
hooks.
NOTE: The ribbon cable that attaches to the control panel assembly connects
to the PLANAR connector on the SCSI backplane and then continues on to the
BACKPLANE connector on the system board.
ribbon cable
thumbscrew
control panel