Service Manual

4-10 Dell PowerEdge 6300 Systems Service Manual
4. If the drive is a SCSI drive, record the setting of the SCSI address
jumpers and SCSI bus termination jumper.
5. If the drive is a SCSI drive, remove the 50-pin-to-68-pin adapter
from the SCSI connector on the back of the drive (if present).
Some drives use a 50-pin-to-68-pin adapter between the SCSI cable and
the drive connector. Check the back of the drive for an adapter, if present;
remove it and retain it for use on the new drive.
NOTES: When you install a 5.25-inch drive, install drive rails and slide the drive
into its bay until the rails snap securely into place.
When you reinstall a SCSI drive, set the SCSI address jumpers and the SCSI
bus termination jumpers to the settings you recorded.