Service Manual

Removing and Replacing Parts 4-23
Expansion Cards
Figure 4-18. Expansion-Card Access Door
NOTE: PCI cards are not hot-pluggable under Microsoft
®
Windows
®
95 or
Windows NT
®
4.x operating systems. They will become hot-pluggable under
Windows NT 5.0, when available.
To remove an expansion card, follow these steps:
1. Unlock the keylock, remove the key, and then turn the keylock to
the access door release position (see Figure 4-18).
2. Squeeze the dual latches on the access door to open the door,
exposing the expansion-card compartment.
3. Disconnect any cables attached to the expansion card you want to
remove.
Be sure to record the location of each cable before you disconnect it.
keylock in access-door release
position
latches (2)