Service Manual

4-28 Dell PowerEdge 6300 Systems Service Manual
Terminator Cartridge
Figure 4-24. Terminator Cartridge Removal
To remove a terminator cartridge, follow these steps:
1. Remove the interior support panel.
2. Press outward on the two SEC cartridge release latches until they
snap into the open position (see Figure 4-24).
3. Pull the terminator cartridge straight up out of the connector and
guide bracket assembly (some force may be required).
To install a terminator cartridge, make sure the cartridge release latches are in
the open position, orient the terminator cartridge in the guide bracket assem-
bly as shown in Figure 4-24, seat it firmly, and then snap the release latches
back into place.
terminator
cartridge
guide bracket
assembly
release
latches (2)