Service Manual

4-30 Dell PowerEdge 6300 Systems Service Manual
System Board Assembly
Figure 4-26. System-Board Assembly Removal
The system board assembly consists of the system board and a mounting
plate. The system board is held to the mounting plate with screws and mount-
ing clips.
To remove the system board assembly follow these steps:
1. Disconnect all cables from the system board.
Be sure to record where each cable is attached.
2. To remove the system board tray, first release the tray latch at the
back lower corner of the tray (see Figure 4-26) and pull the tray
open to the service position. Then depress the latch again and
pull the tray out of the chassis.
system
board tray
tray
latch