Service Manual

4-32 Dell PowerEdge 6300 Systems Service Manual
Guide Bracket Assembly
Figure 4-28. Guide-Bracket Assembly Removal
To remove the guide bracket assembly, follow these steps:
1. Remove the system board assembly.
2. Remove the system board from the system board tray.
3. Remove terminator card and SEC cartridge heat sink assemblies
if necessary.
4. From the underside of the system board, use a T25 Torx driver to
remove the screws at each end of the bracket(s) (see Figure 4-28).
5. For each guide bracket, squeeze the bracket retaining tabs on the
underside of the system board to release the bracket, and pull
the bracket away from the system board.
NOTE: Because of the way the guide brackets overlap each other, the guide
bracket assembly must be removed in the following order: PROC_4 (the bot-
tom bracket when system is standing upright), PROC_3, PROC_2, PROC_1.
Reinstall them in reverse order.