Users Guide

Installing and Configuring SCSI Drivers 3-17
b. From the menu that appears, select Run System Utilities.
c. From the Run System Utilities menu, select Create Utility Partition.
d. At the Welcome... screen, select OK and press <Enter>.
e. At the message Installation completed successfully, select OK
and press <Enter>.
f. Select Exit and press <Enter>.
g. At the Exit Confirmation dialog box, remove the Dell Server Assistant CD,
insert the Dell IntranetWare Support CD, select OK, and press <Enter> to
reboot the server.
2. If you have not already done so, insert the Dell IntranetWare Support
CD into the server’s CD-ROM and reboot the system.
3. From the menu that appears, type 1 to select Create a Primary DOS
Partition.
4. At the next menu, type 2 to select Run FDISK in Automated Mode.
NOTE: Dell recommends running the fdisk utility in automated mode unless you
need to specify a different size for the primary MS-DOS partition. Running the
fdisk utility in automated mode creates a 25-MB partition.
5. At the Warning... screen, read the information and type y to continue.
The program partitions and then reboots the system.
6. From the main menu that reappears, type 2 to select Format Primary
DOS Partition.
7. When prompted, type y and press <Enter> to proceed with the format.
8. From the main menu that reappears, type 4 to select Recreate DOS
System Files on HD.
9. Read the message that appears and type y to continue.
The message FILE TRANSFER COMPLETE appears briefly, and then you are
returned to the main menu.
10. Type q and press <Enter> to exit the utility, then remove the Dell
IntranetWare Support CD from the drive, and press <Ctrl><Alt><Del>
to reboot the system.
Your hard-disk drive has been prepared for NetWare installation. Continue to the
next subsection, “Installing NetWare 4.11.”