Users Guide
Table Of Contents
- SAS Information Update
- SAS 信息更新
- Mise à jour des informations sur les configurations SAS
- Aktuelle Informationen zu SAS
- SAS のアップデート情報
- SAS 정보 업데이트
- Actualización de información sobre SAS
10 SAS Information Update
Figure 1-3. Removing and Installing a Hot-Plug Hard Drive
Installing a Hot-Plug Hard Drive
NOTICE: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard-drive
carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed
carrier's shield spring and make it unusable.
NOTICE: Not all operating systems support hot-plug drive installation. See the documentation supplied with your
operating system.
1 Remove the front bezel, if attached.
See "Opening the System" in your
Installation and
Troubleshooting Guide
.
2
If a drive blank is present in the bay, remove it. See "Removing a Drive Blank" on page 8.
3
Install the hot-plug hard drive.
a
Open the handle on the hard-drive carrier.
b
Insert the hard-drive carrier into the drive bay until the carrier contacts the backplane.
c
Close the handle to lock the drive in place.
4 Replace the front bezel, if it was removed in
step 1.
1 hard drive 2 drive carrier 3 drive carrier release handle
3
1
2