Users Guide

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."
5. Remove the cooling shroud. See "Removing the Cooling Shroud" in "Installing System Options."
6. Disconnect the interface and power cables to the hard drives in the drive bay.
7. Remove the hard-drive bay. See Figure7-5 and Figure7-6.
a. Loosen the four screws that secure the drive bay to the system.
b. Slide the hard-drive bay out of the system.
8. Remove the drive from the drive bay. See Figure7-5 and Figure7-6.
a. Remove the screws that secure the drive in the hard-drive bay.
b. Slide the drive out of the drive bay.
Figure 7-5. Removing a SATA Hard Drive

Figure 7-6. Removing a Cabled SCSI Hard Drive

CAUTION: See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.