Users Guide



If you are installing up to four SATA hard drives:
a. Install a SATA RAID controller card in a 64-bit/66-MHz expansion slot. See FigureA-3 to identify the expansion slots.
b. Connect the SATA cable assembly to port 0 through port 3 on the SATA RAID controller card and to drive 0 through drive 3, respectively. See
Figure7-8.
Figure 7-8. Connecting Four Drives to a SATA RAID Controller Card


If you are installing a cabled SCSI drive, connect the SCSI interface cable to the hard drives and to the SCSI controller card. See Figure7-9.
Figure 7-9. Cabling Four SCSI Hard Drives to the SCSI Controller Card

NOTE: The integrated drive controller on the system board can support only two SATA hard drives. If you are installing three or four SATA hard
drives, you must connect the drives to a SATA RAID controller card in a RAID or non-RAID configuration.