User guide

www.dell.com | support.dell.com
About Cautions
CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.
Installing the Optional CD Drive
CAUTION: See your System Information Guide for complete information about safety precautions,
working inside the computer, and protecting against electrostatic discharge.
NOTE: For additional information about removing system components, see the Installation
and Troubleshooting Guide.
1
If applicable, remove the bezel.
a If applicable, unlock the bezel.
b While grasping the bezel, slide it toward the key lock.
c Rotate the right side of the bezel away from the front panel.
d Pull the bezel away from the system.
2 Turn off the system and attached peripherals, and disconnect the system from the electrical
outlet.
3 To remove the system cover, loosen the two captive screws at the back of the system.
4 While pressing down on the cover indention, slide the cover backward about an inch,
and grasp the cover on both sides.
5 Carefully lift the cover away from the system.
6 Align the CD drive's mounting holes with the retaining pins on the hard drive 0 bracket.
See Figure 1.
7 Rotate the drive downward until it snaps into place.
8 Connect the interposer card to the CD drive.
9 Push the plungers into the fastener barrels until they snap into place.
10 Connect the interface and power cables.
a Connect the CD-ROM connector of the interface cable to the CD drive’s interposer
card.
b Connect the PLNR connector of the interface cable to system board connector Pri-IDE.
See Figure A-3 in your
Installation and Troubleshooting Guide for connector locations.
December 2003
0C3740A00
C3740am0.fm Page 1 Tuesday, December 16, 2003 5:31 PM