Setup Guide

Using the Baseboard Management Controller 17
View the following information provided on the Console Redirection page to ensure that a console
redirection session is available.
Email Alert Destination
When the Dell Remote Management Controller senses a platform event, such as an environmental
warning or a component failure, an alert message can be sent to one or more email addresses. The
Email Alert Destination window enables you to enter email addresses, IP addresses, and to activate
the alerts for each address.
To set up a destination to receive alerts, perform the following steps:
1 Click an Email Alert Number .
The
Set Email Alert window displays.
2 Enable/Disable the alert email address, enter the destination email address, and enter a brief
description for the
Subject of the email.
3 Click Apply Changes .
4 Click Go Back To the Email Alert Destination Page .
5 Enter the SMTP (e-mail) Server IP Address settings.
6 Click Apply Changes .
Table 1-15. Console Redirection Configuration
Item Description
Enabled Checked indicates enabled; unchecked indicates disabled.
Max Sessions View the maximum number of console redirection sessions that are
possible.
Active Sessions View the number of active console sessions.
Video Encryption Enabled Checked indicates enabled; unchecked indicates disabled.
Table 1-16. Destination Email Address
Item Description
Email Alert Number You can set up to four email destinations to receive alerts.
State Enabled indicates that the email address settings are active.
Disabled indicates that the email address settings are not active.
Destination Email Address The email address that receives the alert messages.