Setup Guide

Using the Baseboard Management Controller 19

Platform Events

All alert settings can be enabled or disabled. To change the setting for all alerts, perform the

following steps:

Enter all event actions and alerts.

To activate all alert settings that have been defined in the

Set Platform Events

window, mark

the

Enable Platform Event Filter

alerts checkbox.

To deactivate all alert settings that have been defined in the

Set Platform Events

window,

clear the

Enable Platform Event Filter

alerts checkbox.

Click

Apply Changes

The

Platform Event Filters List

displays the actions that execute when an event occurs. An event

occurs when the status of a system element is outside a set limit. The event list also indicates if an

alert is enabled or disabled for each event.

Table 1-21 provides the Actions and Alerts that can occur when an event is out of bounds. Only one

action can be set for each event.

Table 1-19. IPMI Settings

Settings Description

Enable IPMI Over LAN Enable IPMI LAN Channel

Channel Privilege Level Limit The maximum privilege level that can be accepted on the LAN

Channel.

Encryption Key Format: 0 to 20 bytes (even number of hexadecimal characters, no

blank spaces are allowed).

Table 1-20. VLAN Settings

Settings Description

Enable VLAN ID If enabled, only matched VLAN ID traffic is accepted.

VLAN ID VLAN ID field of 802.1g fields. Enter a valid value for Virtual LAN ID

(must be a number from 1 to 4094).

Priority Priority field of 802.1g fields. Enter a number from 0 to 7 to set the

Priority of the Virtual LAN ID.