Setup Guide

20 Using the Baseboard Management Controller

www.dell.com | support.dell.com

To set up the actions and alerts, perform the following steps:

Click the

Event

name in the

Platform Event Filters List

The

Set Platform Events

window for that event opens.

Set the

Shutdown Action

and

Alert Setting

for the event.

Repeat steps 1 and 2 for each event.

To enable the settings, see the platform event filters configuration procedure.

Serial Over LAN Configuration

To configure the

Serial Over LAN Configuration Advanced Setting

s, select values for each

attribute in Table 1-22, and click

Apply Changes

To enable and configure the

Serial Over LAN Configuration

, click

Return to Serial Over LAN

Configuration Page

at the bottom of the window.

Table 1-21. Platform Event Filters List

Action Description

Reboot System When an event occurs, the system restarts (a warm boot).

Power Cycle System When an event occurs, the system shuts down, powers off, and

restarts (a cold boot).

Power Off System When an event occurs, the system shuts down and powers off.

Generate Alert An alert or platform event trap is sent when the event occurs. The

email server and address to which the alert is sent, can be set in the

Configuration Email Alert Settings window.

Event trap destinations can be set in the Configuration Trap

Settings window.

Table 1-22. Serial Over LAN configuration

Item Description

Enable Serial Over LAN Checked indicates enabled; Unchecked indicates disabled

Baud rate Select a IPMI data speed of 9600 bps, 19.2 kbps, 38.4 kbps, 57.6 kbps,

or 115.2 kbps

Privilege level Select the IPMI Serial Over LAN minimum user privilege:

Administrator, Operator, or User.