Setup Guide

28 Using the Baseboard Management Controller
www.dell.com | support.dell.com
Table 1-32 shows the chassis commands.
Table 1-33 shows the event commands.
Table 1-32. Chassis Commands
Commands NetFn CMD O/M Supported
Get Chassis Capabilities Chassis 00h M Yes
Get Chassis Status Chassis 01h M Yes
Chassis Control Chassis 02h M Yes
Chassis Reset Chassis 03h O No
Chassis Identify Chassis 04h O Yes
Set Chassis Capabilities Chassis 05h O Yes
Set Power Restore Policy Chassis 06h O Yes
Get System Reset Cause Chassis 07h M Yes
Set System Boot Options Chassis 08h M Yes
Get System Boot Options Chassis 09h M Yes
Set Front Panel Button Enable Chassis 0Ah M Yes
Set Power Cycle Interval Chassis 0Bh M Yes
Get POH Counter Chassis 0Fh O No
Table 1-33. Event Commands
Commands NetFn CMD O/M Supported
Set Event Receiver S/E 00h M M
Get Event Receiver S/E 01h M M
Platform Event S/E 02h M M