Users Guide

Table 2. Status LED indicators (continued)
Icon Description Condition Corrective action
PCIe indicator The indicator turns solid amber if a
PCIe card experiences an error.
Restart the system. Update any required drivers for
the PCIe card. Reinstall the card. If the problem
persists, see the Getting help section.
NOTE: For more information about the supported
PCIe cards, see the Expansion card installation
guidelines section.
System health and system ID indicator codes
Figure 1. System health and system ID indicators
Table 3. System health and system ID indicator codes
System health and system ID indicator code Condition
Blue solid
Indicates that the system is turned on, system is healthy and
system ID mode is not active. Press the system health and
system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system
health and system ID button to switch to system health mode.
Amber solid Indicates that the system is in fail-safe mode. If the problem
persists, see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check the
System Event Log or the LCD panel, if available on the bezel,
for specific error message. For information about the event and
error messages generated by the system firmware and agents
that monitor system components, go to qrl.dell.com > Look Up >
Error Code, type the error code, and then click Look it up.
iDRAC Quick Sync 2 indicator codes
NOTE: iDRAC Quick Sync 2 module (optional) is located on the left control panel of your system.
Figure 2. iDRAC Quick Sync 2 indicators
Table 4. iDRAC Quick Sync 2 indicators
Wireless indicator code Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC
Quick Sync 2 button to turn on the
iDRAC Quick Sync 2 feature.
If the LED fails to turn on, reseat the left control
panel flex cable and check again. If the problem
persists, see the Getting help section.
Diagnostic indicators 11