Reference Guide

{enabled|disabled|default}] [-name <VD name>] [-size <VD size>{b|k|m|g|

t}] [-T10PIEnable]

racadm storage init:<VD FQDD> -speed {fast|full}

racadm storage deletevd:<VD FQDD>

racadm storage encryptvd:<VD FQDD>

racadm storage createsecuritykey:<Controller FQDD> -key <Key id> -xxx

racadm storage modifysecuritykey:<Controller FQDD> -key <Key id>-xxx <old

passphrase> -xxx <new passphrase>

racadm storage deletesecuritykey:<Controller FQDD>

racadm storage ccheck:<vdisk fqdd>

racadm storage cancelcheck:<vdisk fqdd>

• To convert the physical disk drives and assign or delete a hotspare. To scan physical disks connected to a

controller and detect problem, run the following command:

racadm storage converttononraid:<PD FQDD>

racadm storage converttoraid:<PD FQDD>

racadm storage hotspare:<Physical Disk FQDD> -assign yes -type dhs -

vdkey: <FQDD of VD>

racadm storage hotspare:<Physical Disk FQDD> -assign yes –type ghs

racadm storage hotspare:<Physical Disk FQDD> -assign no

racadm storage patrolread:<controller FQDD> -state start|stop

NOTE: If the –assign option is no, you cannot add other options. If the –assign option is yes

and if the -type option is not present, the global hotspare (ghs) is created by default.

• To reset, clear, and import the storage conguration to the controller, run the following command:

racadm storage importconfig:<Controller FQDD>

racadm storage resetconfig:<Controller FQDD>

racadm storage clearconfig:<Controller FQDD>

• To start or stop a blink or identify operation on the specied or PCIeSSD device, run the following

command:

racadm storage blink:<FQDD>

racadm storage blink:<PCIeSSD FQDD>

racadm storage unblink:<FQDD>

racadm storage unblink:<PCIeSSD FQDD>

NOTE: The Start or Stop a Blink feature is not supported for HHHL PCIe SSD devices.

• To prepare the PCIeSSD drive for removal, run the following command:

racadm storage preparetoremove <PCIeSSD FQDD>

NOTE: The Prepare to Remove task is not supported for HHHL PCIe SSD devices.

• To perform a secure erase operation on PCIeSSD device, run the following command:

racadm storage secureerase:<PCIeSSD FQDD>

NOTE: You can also run the command using raid in place of the storage command.

Input

• -o — Species the optimized version.

• -p — Species the property name.

• --refkey — Species the controller or enclosure FQDDs.

• -rl — Sets the storage level.