Reference Guide
• View the current test trap settings.
racadm get iDRAC.SNMP.Alert.<index>
where <index> is a number from 1 to 8
testalert
Description Tests FQDN supported SNMP trap notications.
To run this subcommand, you must have the Test Alert User Access.
Synopsis
racadm testalert -i <index>
Input -i — Species the index of the trap test. index must be an integer from 1 to 8 on iDRAC.
Output
Success: Test trap sent successfully
Failure: Unable to send test trap
Example
• Test a trap with index as 1.
racadm testalert -i 1
Test trap sent successfully.
• Test a trap that has not been congured yet.
racadm testalert -i 2
ERROR: Trap at specified index is not currently enabled.
traceroute
Description
Traces network path of the routers as the packets traverse from the system to a destination IPv4 address.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute <IPv4 address>
Input IPv4 — Species IPv4 address.
Output
traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms
traceroute6
Description
Traces the network path of routers as the packets traverse from the system to a destination IPv6 address.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute6 <IPv6address>
Input <IPv6address> – Species IPv6 address.
Output
traceroute to fd01::1 (fd01::1) from fd01::3,
30 hops max, 16 byte packets
1 fd01::1 (fd01::1) 14.324 ms 0.26 ms 0.244 ms
95