Reference Guide

Option Description
System Memory
Speed
Specifies the system memory speed.
System Memory
Voltage
Specifies the system memory voltage.
Video Memory Specifies the amount of video memory.
System Memory
Testing
Specifies whether the system memory tests are run during system boot. Options are Enabled and
Disabled. This option is set to Disabled by default.
Dram Refresh
Delay
By enabling the CPU memory controller to delay running the REFRESH commands, you can improve
the performance for some workloads. By minimizing the delay time, it is ensured that the memory
controller runs the REFRESH command at regular intervals. For lntel-based servers, this setting only
affects systems configured with DIMMs which use 8 Gb density DRAMS.
Memory
Operating Mode
Specifies the memory operating mode. The options available are Optimizer Mode, Single Rank Spare
Mode, Multi Rank Spare Mode, Mirror Mode, and Dell Fault Resilient Mode. This option is set to
Optimizer Mode by default.
NOTE: The Memory Operating Mode option can have different default and available options based
on the memory configuration of your system.
NOTE: The Dell Fault Resilient Mode option establishes an area of memory that is fault resilient.
This mode can be used by an operating system that supports the feature to load critical applications
or enables the operating system kernel to maximize system availability.
Current State of
Memory
Operating Mode
Specifies the current state of the memory operating mode.
Fault Resilient
Mode Memory
Size [%]
Select to define the percent of total memory size that must be used by the fault resilient mode when
selected in the Memory Operating mode. When Fault Resilient Mode is not selected, this option is
grayed out and not used by Fault Resilient Mode.
Node Interleaving Specifies if Non-Uniform Memory Architecture (NUMA) is supported. If this field is set to Enabled,
memory interleaving is supported if a symmetric memory configuration is installed. If this field is set to
Disabled, the system supports NUMA (asymmetric) memory configurations. This option is set to
Disabled by default.
ADDDC Setting Enables or disables ADDDC Setting feature. When Adaptive Double DRAM Device Correction (ADDDC)
is enabled, failing DRAMs are dynamically mapped out. When set to Enabled it can have some impact to
system performance under certain workloads. This feature is applicable for x4 DIMMs only. This option is
set to Enabled by default.
Native tRFC
Timing for 16Gb
DIMMs
Enables 16 Gb density DIMMs to operate at their programmed Row Refresh Cycle Time (tRFC). Enabling
this feature may improve system performance for some configurations. However, enabling this feature
has no effect on configurations with 16 Gb 3DS/TSV DIMMs. This option is set to Enabled by default.
Opportunistic
Self-Refresh
Enables or disables opportunistic self-refresh feature. This option is set to Disabled by default and is not
supported when DCPMMs are in the system.
Correctable Error
logging
Enables or disables logging of correctable memory threshold error. This option is set to Enabled by
default.
8 Pre-operating system management applications