Owners Manual

Table Of Contents
226 | Removing and Installing System Components
Optional Mezzanine Cards
Removing the LSI 2008 SAS Mezzanine Card
NOTE:
The LSI 2008 SAS mezzanine card is seated in PCI-E Gen3 x8 mezzanine
slot 3 on the system board, which is not active in 1-processor configuration. See
C6220 II System Board Connectorson page 331 and “C6220 System Board
Connectors” on page 332 for the location.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1. Remove the system-board assembly. See “Removing a System-
Board Assembly" on page 172.
2. Disconnect all the cables from the LSI 2008 SAS mezzanine card.
3. Remove the three screws that secure the LSI 2008 SAS
mezzanine card. See Figure 3-50.
4. Lift the LSI 2008 SAS mezzanine card out of the system-board
assembly. See Figure 3-50.