Owners Manual

246 | Removing and Installing System Components
Installing the Memory Modules
WARNING: The memory modules are hot to the touch for some time after the
system has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges and
avoid touching the components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1. Press down and out on the ejectors on each end of the memory
module socket. See Figure 3-65.
2. Align the memory module correctly with the alignment key of
the memory module socket. See Figure 3-65.
3. Press down firmly on the memory module with your thumbs
until the module snaps into place. See Figure 3-65.
CAUTION: Even pressure during insertion must be applied at both ends of the
module simultaneously to prevent damage to the socket. No pressure should
be applied to the center of the module.
Complete the latching of the module into the socket by applying
inward pressure to the socket ejectors to assure that the ejectors
are in a locked position. When the memory module is properly
seated in the socket, the ejectors on the memory module socket
align with the ejectors on other identical sockets that have
memory modules installed.