Owners Manual

Removing and Installing System Components | 267
CAUTION: If removed, you must replace the power distribution board 2 and the
power distribution board-connector before replacing the power distribution
board 1.
1. If removed, first place the power distribution board 2 in the
system. See Figure 3-80. Otherwise skip to step 5.
NOTE: To install the power distribution board 2 below the power distribution
board 1, angle the board during installation.
2. Replace the screws securing the power distribution board 2 to
the system. See Figure 3-80.
3. Replace the power distribution board-connector. See Figure 3-
79.
4. Connect all the cables to the power distribution board 2. See
Figure 3-82.
You must route these cables properly through the tabs on the
chassis to prevent them from being pinched or crimped.
5. Replace the power distribution board 1 to the system. See Figure
3-78.
6. Replace the screws securing the power distribution board 1 to
the system. See Figure 3-78.
7. Connect all the cables to the power distribution board 1. See
Figure 3-81.
You must route these cables properly through the tabs on the
chassis to prevent them from being pinched or crimped.
8. Replace the power supply. See “Installing a Power Supply” on
page 169.
9. Close the system. See “Closing the System” on page 154.
10. Reconnect the system to its electrical outlet and turn on the
system, including any attached peripherals.