Owners Manual

Removing and Installing System Components | 313
3. Replace the screw that secures the sensor board to the hard
drive cage. See Figure 3-112.
4. Connect the sensor board cable to the sensor board. See Figure
3-114.
5. Replace the hard drive cage into the chassis. See Figure 3-99.
6. Replace the screws that secure the hard-drive cage to the
chassis. See Figure 3-98.
7. Connect all the cables to the backplane. See Figure 3-97 for 2.5-
inch hard drives.
You must route these cables properly on the chassis to prevent
them from being pinched or crimped.
8. Connect the front panel cables to the power distribution board.
See Figure 3-111 or Figure 3-114.
You must route these cables properly on the chassis to prevent
them from being pinched or crimped.
9. Close the system. See “Closing the System” on page 154.
10. Replace the hard drives. See “Installing a Hard Drive into a Hard-
Drive Carrier” on page 165.
11. Reconnect the system to its electrical outlet and turn on the
system, including any attached peripherals.
Cable Routing for Sensor Board and Front Panel for 2.5” Hard Drive
System
1. Connect the Y-shaped cable for the sensor board and front
panel 2 to the connector on the power distribution board 1, and
connect the other two ends of the cable to the connectors on
the sensor board and the front panel 2 respectively.
2. Connect the front panel cable to the connector on the power
distribution board 1, and connect the other end of the cable to
the connector on the front panel 1.