Owners Manual

Figure 54. Removing and installing the riser card
a. screw (2)
b. riser card
c. expansion card bracket
Next steps
1. Install the riser card.
2. If removed, install the expansion card.
3. Install the expansion card riser assembly.
4. Install the sled into the enclosure.
5. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 62
Related tasks
Removing a sled on page 87
Removing the expansion card on page 97
Installing the riser card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the expansion card riser assembly.
5. If installed, remove the expansion card.
6. Keep the Phillips #2 screwdriver ready.
Steps
1. Place the riser card into the expansion card bracket.
102
Installing and removing system components