Owners Manual

Table 29. Supported mezzanine cards (continued)

Type Card

Single Port QSFP+ ConnectX4 VPI

Dual Port SFP ConnectX4 LX

Removing the optional LSI 2008 SAS mezzanine card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: The LSI 2008 SAS mezzanine card is seated in PCI-E Gen3 x8 mezzanine slot 3 on the system board, which is not

active in 1-processor configuration. See the C6320 system board connectors section.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Turn off the system, including any attached peripherals.

3. Disconnect the system from the electrical outlet and disconnect the peripherals.

4. Remove the system board assembly.

Steps

1. Disconnect all the cables from the mezzanine card.

2. Remove the screws that secure the LSI 2008 SAS mezzanine card.

3. Lift the mezzanine card out of the system-board assembly.

Figure 56. Removing and installing the LSI 2008 SAS mezzanine card

screw (3) 2. LSI 2008 SAS mezzanine card

3. card bridge card 4. system board assembly

Related references

Safety instructions on page 62

C6320 system board connectors on page 162

104

Installing and removing system components