Owners Manual

5. Complete the latching of the module into the socket by applying inward pressure to the socket ejectors to ensure that the
ejectors are in a locked position. When the memory module is properly seated in the socket, the ejectors on the memory
module socket align with the ejectors on other identical sockets that have memory modules installed.
Figure 68. Installing a memory module
Figure 69. Installing a memory module
a. memory module
b. alignment key
c. memory module socket ejector (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
3. Install the system board assembly.
4. To enter System Setup, press F2 and check the System Memory setting.
5. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory modules
are firmly seated in the sockets.
6. Run the system memory test in the system diagnostics.
Related references
Safety instructions on page 62
Installing and removing system components
117