Owners Manual

Related references
Safety instructions on page 62
Related tasks
Before working inside your system on page 63
Removing a hard drive carrier on page 71
Removing the system cover on page 64
Installing the control panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE: Additional tape maybe required to secure the cables.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the control panel.
4. Keep the Phillips #1 screwdriver ready.
Steps
1. Connect the control panel cable to the control panel.
2. Push aside the retention hooks on the control panel assembly and place the control panel into the control panel assembly.
3. Install the control panel assembly into the hard drive cage.
Figure 118. Installing the left side control panel
Installing and removing system components
155