Owners Manual

Steps
1. Install the sensor board into the hard drive cage.
2. Install the screw that secures the sensor board to the hard drive cage.
3. Connect the sensor board cable to the sensor board.
Next steps
1. Install the hard drive cage into the chassis.
2. Install the screws that secure the hard drive cage to the chassis.
3. Connect all the cables to the backplane.
4. Connect front panel cables to the power distribution board.
5. Install the hard drives.
6. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 62
Related tasks
Installing the system cover on page 65
Installing a hard drive into a hard drive carrier on page 74
After working inside your system on page 63
Cable routing for sensor board and control panel for 3.5-inch hard
drive system
Steps
1. Connect the Y-shaped cable for sensor board and control panel 2 to the connector on the power distribution board 1, and
connect the other two ends of the cable to the connectors on the sensor board and the control panel 2 respectively.
2. Connect the control panel cable to the connector on the power distribution board 1, and connect the other end of the cable
to the connector on the control panel 1.
Figure 121. Cable routing−sensor board and control panel
158
Installing and removing system components