Manualshelf

Owners Manual

ManualsBrandsDell ManualsC SeriesPowerEdge C6300
161162163164165166167168169170
Cable routing for sensor board and control panel for 2.5-inch hard
drive system
Steps
1. Connect the Y-shaped cable for the sensor board and control panel 2 to the connector on the power distribution board 1,
and connect the other two ends of the cable to the connectors on the sensor board and the control panel 2 respectively.
2. Connect the control panel cable to the connector on the power distribution board 1, and connect the other end of the cable
to the connector on the control panel 1.
Figure 122. Cable routing−sensor board and control panel
Table 44. Cable routing−sensor board and control panel
Item Cable From (power
distribution board)
To (sensor board and control panels)
Sensor board
cable
Sensor board power
connector (J1)
Sensor board
Front panel cable Front panel connector
(J16)
Front panel 2
Front panel cable Front panel connector
(J18)
Front panel 1
Installing and removing system components 161