Owners Manual

Option Description
I/O Snoop
Holdoff
Response
Selects the number of cycles PCI I/O can withhold snoop requests from the CPU, to allow time to
complete its own write to LLC. This setting can help improve performance on workloads where
throughput and latency are critical.
Embedded Video
Controller
Enables or disables the Embedded Video Controller option. This option is set to Enabled by default.
Current State of
Embedded Video
Controller
Displays the current state of the embedded video controller. The Current State of Embedded Video
Controller option is a read-only field. If the Embedded Video Controller is the only display capability in the
system (that is, no add-in graphics card is installed), then the Embedded Video Controller is automatically
used as the primary display even if the Embedded Video Controller setting is set to Disabled.
SR-IOV Global
Enable
Enables or disables the BIOS configuration of Single Root I/O Virtualization (SR-IOV) devices. This option
is set to Disabled by default.
OS Watchdog
Timer
If your system stops responding, this watchdog timer aids in the recovery of your operating system. When
this option is set to Enabled, the operating system initializes the timer. When this option is set to
Disabled (the default), the timer does not have any effect on the system.
Memory Mapped
I/O above 4 GB
Enables or disables the support for PCIe devices that need large amounts of memory. This option is set to
Enabled by default.
Slot Disablement Enables or disables the available PCIe slots on your system. The slot disablement feature controls the
configuration of PCIe cards installed in the specified slot. Slots must be disabled only when the installed
peripheral card prevents booting into the operating system or causes delays in system startup. If the slot
is disabled, both the Option ROM and UEFI drivers are disabled.
Related concepts
Integrated Devices on page 48
Related tasks
Viewing Integrated Devices on page 49
Serial Communication
You can use the Serial Communication screen to view the properties of the serial communication port.
Related concepts
System BIOS on page 35
Related tasks
Serial Communication details on page 51
Viewing Serial Communication on page 50
Viewing Serial Communication
To view the Serial Communication screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
50
Pre-operating system management applications