Owners Manual

Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Align the space supports with the holes on the BBU bracket, and press the DC to DC board until the retaining clips flip.
Figure 36. Installing the DC to DC board
a. BBU Bracket
b. space support (2)
c. DC to DC board
2. Reconnect all the cables.
Next steps
1. Install the system board.
2. Reconnect the peripherals and connect the system to the electrical outlet.
3. Turn on the system, including any attached peripherals.
Cable routings for SSD and DC to DC board and LSI 2008
About this task
Table 25. Cable routings for SSD and DC to DC Board and LSI 2008
Item Cable From (LSI 2008 SAS Mezzanine card) To (System board)
1 Mini-SAS cable
Mini-SAS connector 4-7 (J4)
On LSI 2008 SAS Mezzanine Card
SAS/SATA connectors 4&5
2
Mini-SAS connector 0 - 3 (J3)
On LSI 2008 SAS Mezzanine Card
Mini-SAS HD Connector 0-3
3 MicroSATA cable 1.8-inch SSD Onboard SATA Connector 5 on the system
board
4 1.8-inch SSD DC to DC board (J2)
5 1x4 power cable DC to DC to DC board (J1) High Power Connector on the system
board
Installing and removing system components 81