Owners Manual

Figure 37. Cable routings for SSD and DC to DC Board and LSI 2008
Table 26. Cable routings for SSD and DC to DC Board and LSI 2008
Item Cable From (LSI 2008 SAS Mezzanine card) To (System board)
Mini-SAS cable
Mini-SAS connector 4-7 (J4)
On LSI 2008 SAS Mezzanine Card
SAS/SATA connectors 4&5
Mini-SAS connector 0-3 (J3)
On LSI 2008 SAS Mezzanine Card
Mini-SAS HD Connector 0-3
MicroSATA cable 1.8-inch SSD Onboard SATA Connector 5 on the system
board
1.8-inch SSD DC to DC board (J2)
1x4 power cable DC to DC to DC board (J1) High Power Connector on the system
board
SATADOM
Removing the SATADOM
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1. Disconnect the power cable from the SATADOM and the system board.
2. Using a screwdriver, press the metal latch to release the SATADOM.
3. Holding the SATADOM by its edges, pull the SATADOM until the card edge connector disengages from the onboard SATA
connector 5 on the system board.
82
Installing and removing system components