Owners Manual

Figure 38. Removing the SATADOM
a. system board assembly
b. SATADOM
c. metal latch
Related references
Safety instructions on page 62
Related tasks
Removing a sled on page 87
Installing the SATADOM
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Holding the SATADOM by its edges, position it so that the card edge connector aligns with the onboard SATA connector 5
on the system board.
2. Press the SATADOM with your thumbs until it is fully seated.
3. Reconnect all the cables.
Next steps
1. Reconnect the peripherals and connect the system to the electrical outlet.
2. Turn on the system, including any attached peripherals.
Related references
Safety instructions on page 62
Related tasks
Installing a sled on page 89
Installing and removing system components
83