Owners Manual

Installing a sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the sled blank from the enclosure.
NOTE: The process to remove the sled blank is the same as removing a sled.
4. Keep the Phillips #2 screwdriver ready.
Steps
1. Slide the sled into the enclosure until it locks into place.
2. Replace the screw that secures the retaining latch.
Figure 44. Installing a sled
Next steps
Follow the procedure listed in the After working inside your system section.
NOTE:
To add the Service Tag of the system board to match the Service Tag of the physical node, contact Dell Technical
Support.
Related references
Safety instructions on page 62
Installing and removing system components
89