Owners Manual

Figure 46. Removing the cooling shroud
a. cooling shroud
b. system board assembly
Next steps
1. Install the cooling shroud.
2. Install the sled into the enclosure.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 62
Related tasks
Removing a sled on page 87
Installing the cooling shroud
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Insert the cooling shroud into the sled, aligning the latches with the lock slots on the sled chassis.
NOTE: Ensure that the SATA cable is routed through the cooling shroud cable guide slot.
2. Press the cooling shroud until the locks click into place.
Installing and removing system components
91