Owners Manual

Figure 51. Removing the expansion card assembly
a. expansion card assembly
b. screw (4)
c. system board assembly
3. Remove the screw that secures the expansion card.
4. Hold the expansion card by its edges, and carefully remove it from the riser card.
NOTE:
If you are removing the card permanently, install an expansion card slot cover over the empty expansion slot
opening, and close the expansion card latch.
NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal Communications Commission
(FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and
airflow inside the system.
Figure 52. Removing the expansion card
1.
expansion card slot cover 2. screw
3. expansion card 4. riser card
Related references
Safety instructions on page 62
98
Installing and removing system components