Owners Manual

Removing the expansion card riser assembly on page 106
Installing a mezzanine card on page 122
Installing a mezzanine card filler bracket on page 128
Installing the expansion card riser assembly on page 107
Installing a sled on page 72
After working inside your system on page 68
Installing a mezzanine card filler bracket
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the expansion card riser assembly.
5. Keep the Phillips #1 screwdriver ready.
Steps
1. Install the mezzanine card filler bracket into the sled.
2. Secure the mezzanine card filler bracket with screws.
Figure 70. Installing a mezzanine card filler bracket
Next steps
1. Install the expansion card riser assembly.
128
Installing and removing sled components