Owners Manual

Next steps
1. Install the sled into the enclosure.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 67
Removing a sled on page 71
Removing the system battery - option A on page 129
Installing a sled on page 72
After working inside your system on page 68
Removing the system battery - option B
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Take the sled out of the enclosure.
Steps
1. Locate the battery socket. For more information, see the System board connectors section.
2. Slant the battery away from the battery holder and pull the battery out of the socket.
Figure 73. Removing the system battery - clamp type holder
Next steps
1. Install the system battery.
2. Install the sled into the enclosure.
3. Follow the procedure listed in the After working inside your system section.
Installing and removing sled components
131