Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
NOTE:
● Install expander firmware 2.07 or later to support these configurations
● The expander mode works only with a PERC card, and is not supported by the onboard SATA controller.
Diagnostic indicators
The diagnostic indicators on the system indicate operation and error status.
Drive indicator codes
Each drive carrier has an activity LED indicator and a status LED indicator. The indicators provide information about the status
of the drive. The activity LED indicator indicates whether the drive is in use or not. The status LED indicator indicates the power
condition of the drive.
Figure 8. Drive indicators on the drive and the mid drive tray backplane
1. Drive activity LED indicator
Dell EMC PowerEdge C6400 overview
11