Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Figure 27. Removing the drive from the drive carrier
Next steps
1. If applicable, install the drive into the drive carrier.
Installing a drive into the drive carrier
Prerequisites
CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
When aligned correctly, the back of the drive is flush with the back of the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
28
Installing and removing enclosure components