Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Figure 32. Installing the system cover
Next steps
1. Reconnect the peripherals, and connect the system to the electrical outlet.
2. Power on the system, and all attached peripherals.
Backplane cover
Removing the backplane cover
Prerequisites
NOTE: This procedure is not applicable for enclosures with the 3.5-inch hard drive configuration.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your enclosure.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the backplane cover to the enclosure.
2. Slide the backplane cover toward the back of the enclosure and lift the cover away.
34
Installing and removing enclosure components