Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Next steps
1. Follow the procedure listed in After working inside your enclosure.
Cooling fans
Removing a cooling fan
Prerequisites
WARNING: Do not attempt to operate the system without the cooling fans.
WARNING: The cooling fan spins for some time after the system is powered off. Allow the fan to stop spinning
before removing it from the system.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your enclosure.
Steps
Disconnect the fan cable from the connector on the cooling fan cage and lift the fan out.
Figure 35. Removing a cooling fan
Next steps
1. Install a cooling fan.
2. For more information about the fan status, see the management software.
Installing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the cooling fan with the fan slot on the cooling fan cage, and push the cooling fan until it is firmly seated.
2. Connect the fan cable to the connector on the cooling fan cage.
36
Installing and removing enclosure components