Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Figure 56. Removing the 3.5-inch drive cage
Next steps
1. Install the 3.5-inch drive cage.
Installing the 3.5 inch drive cage
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION: You must note the number of each drive and temporarily label them before removal so that you can
replace them in the same locations.
Follow the safety guidelines listed in Safety instructions.
Steps
1. Insert the drive cage into the enclosure, aligning the drive cage with the standoffs on the chassis.
2. Slide the drive cage toward the lock position.
3. Using the Phillips #1 screwdriver, secure the drive cage in place with screws.
54
Installing and removing enclosure components