Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Figure 67. Removing the backplane
Next steps
1. Install the backplane.
Installing the backplane
Prerequisites
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you
can replace them in the same slots.
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
Follow the safety guidelines listed in Safety instructions.
Steps
1. Orient the drive cage so that the drive bays are facing down.
2. Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage.
3. Using the Phillips #2 screwdriver, replace the screws to secure the backplane to the drive cage.
62
Installing and removing enclosure components