Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Steps
1. Using the Phillips #2 screwdriver, remove the screws that secure the backplane expander board to the drive cage.
2. Lift the backplane expander board out of the enclosure.
Figure 69. Removing the backplane expander board
Next steps
1. Install the backplane expander board.
Installing the backplane expander board
Prerequisites
NOTE:
Observe the routing of the cable on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE: The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration.
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Install the backplane expander board into the enclosure, aligning the screw holes on the board with the holes on the drive
cage.
2. Using the Phillips #2 screwdriver, secure the backplane expander board to the chassis.
64
Installing and removing enclosure components