Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6400 Installation and Service Manual
- Dell EMC PowerEdge C6400 overview
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- Drives
- Power supply units
- System cover
- Backplane cover
- Cooling fans
- Power interposer board
- Chassis management board
- Linking board
- Midplane
- Drive cage
- Backplanes and expander board
- Control panel
- Thermal sensor board
- Getting help
- Documentation resources
Installing the thermal sensor board
Prerequisites
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly on the chassis to prevent them from being pinched or crimped.
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Install the thermal sensor board into the sensor board holder, and using the Phillips #1 screwdriver, secure it to the holder.
2. Connect the cable to the sensor board assembly.
3. Install the sensor board assembly into the drive cage.
4. Replace the screw that secures the sensor board assembly to the drive cage.
Figure 76. Installing the sensor board assembly
Next steps
1. Replace the drive cage into the chassis.
2. Connect all the cables to the backplane.
3. Connect the control panel cables to the midplane.
4. Install the drives.
5. Follow the procedure listed in After working inside your enclosure.
Installing and removing enclosure components
69