Dell EMC PowerEdge C6400 Technical Specifications Regulatory Model: E43S Series Regulatory Type: E43S001 December 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2017 - 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Technical specifications............................................................................................... 4 Dimensions of the Dell EMC PowerEdge C6400 enclosure...................................................................................... 4 Chassis weight..................................................................................................................................................................... 5 Supported operating systems....................
1 Technical specifications The technical and environmental specifications of your system are outlined in this section. Topics: • • • • • • • • Dimensions of the Dell EMC PowerEdge C6400 enclosure Chassis weight Supported operating systems PSU specifications Chassis management board specifications Drives and storage specifications Midplane specifications Environmental specifications Dimensions of the Dell EMC PowerEdge C6400 enclosure Figure 1.
Table 1. Dimensions of the PowerEdge C6400 enclosure Xa Xb Y Za Zb Zc 482.6 mm (19 inches) 448 mm (17.63 inches) 86.8 mm (3.41 inches) 26.8 mm (1.05 inches) 763.2 mm (30.28 inches) 797.3 mm (31.38 inches) Chassis weight Table 2. Chassis weight of the Dell EMC PowerEdge C6400 enclosure with PowerEdge C6420 sleds System Maximum weight (with all sleds and drives) 12 x 3.5-inch hard drive systems 43.62 Kg (96.16 lb) 24 x 2.5-inch hard drive systems 41.46 Kg (91.40 lb) No backplane systems 34.
NOTE: If a system with 2000 W AC PSU operates at low line 100–120 V AC, then the power rating per PSU is derated to 1000 W. NOTE: If system with 1600 W AC PSU operates at low line 100–120 V AC, then the power rating per PSU is derated to 800 W. Chassis management board specifications Figure 2. Chassis management board specifications 1. 3. 5. 7. 9. 11.
Table 5. Supported RAID options with M.2 SATA drives Options Single M.2 SATA drive without RAID Dual M.2 SATA drives with hardware RAID Hardware RAID No Yes RAID Mode N/A RAID 1 Number of drives supported 1 2 Supported CPUs CPU 1 CPU 1 and CPU 2 Midplane specifications Figure 3. Midplane specifications 1. Midplane signal connector 2 3. Chassis management board cable connector 5. Midplane power cable ground connector 2. Thermal sensor cable connector 4.
Table 6. Standard operating temperature specifications Standard operating temperature Specifications Temperature ranges (for altitude less than 950 m or 3117 ft) 10°C–35°C (50°F–95°F) with no direct sunlight on the equipment. NOTE: Some configurations require a lower ambient temperature. For more information, see the following tables. Table 7.
Table 7.
Table 7.
Table 7. Maximum continuous operating temperature for nonfabric dual processor configuration (continued) TDP Watts 70 W Process or model Heat sink model Max memo ry/ proce ssor 5215L CPU1: JYKMM | CPU2: V2DRD CPU1: 8| CPU2: 8 35 35 4215 CPU1: JYKMM | CPU2: V2DRD CPU1: 8| CPU2: 8 35 4214 CPU1: JYKMM | CPU2: V2DRD CPU1: 8| CPU2: 8 4214C CPU1: JYKMM | CPU2: V2DRD 3.5-inch chassis 12x Drive s 8x 4x Drive Drive s s No-BP Chassis 2.
Table 8.
Table 8. Maximum continuous operating temperature for non-fabric single processor configuration (continued) TDP Watts Processo r model 115 W 85 W 70 W No-BP Chassis 2.
Table 9. Configuration Restrictions with Mellanox Navi Dual Port Card with Active (Optical) connectivity 3.5-inch chassis TDP Watts No-BP Chassis 2.
Table 10. Configuration Restrictions with Intel Rush Creek (continued) 3.5-inch chassis TDP Watts No-BP Chassis 2.
Expanded operating temperature specifications Table 12. Expanded operating temperature Expanded operating temperature Specifications Continuous operation 5°C–40°C at 5% to 85% RH with maximum 29°C dew point. NOTE: Outside the standard operating temperature (10°C–35°C), the system can operate continuously in temperatures as low as 5°C and as high as 40°C. For temperatures between 35°C and 40°C, derate maximum allowable temperature by 1°C per 175 m above 950 m (1°F per 319 ft).
Temperature specifications Table 15. Temperature specifications Temperature Specifications Storage –40°C–65°C (–40°F to 149°F) Continuous operation (for altitude less than 950 m or 3117 ft) 10°C–35°C (50°F to 95°F) with no direct sunlight on the equipment. Fresh air For information about fresh air, see Expanded Operating Temperature section.
Maximum vibration specifications Table 18. Maximum vibration specifications Maximum vibration Specifications Operating 0.26 Grms at 5 Hz to 350 Hz (all operation orientations). Storage 1.88 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested). Maximum shock specifications Table 19. Maximum shock specifications Maximum shock Specifications Operating 24 executed shock pulses 6 G in the positive and negative x, y, z axis for up to 11 ms (four pulses on each side of the system).
