Owners Manual

Figure 53. Removing the M.2 SATA x16 riser
Next steps
1. Install the M.2 SATA x16 riser.
Installing the M.2 SATA x16 riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Connect the data cable to the riser.
2. Insert the keyed end of the M.2 SATA riser into the lock on the system board.
3. Align and insert the edge connector into the connector on the system board.
4. Using the Phillips #2 screwdriver, tighten the screw to secure the riser to the sled.
104
Installing and removing enclosure components